Allet I think, 48" cylinder @ Stowe.

6 posts / 0 new
Last post
DJD
Offline
Last seen: 13 hours 3 min ago
Joined: 06/09/2013 - 14:19
Allet I think, 48" cylinder @ Stowe.

One of my brothers was the Stowe headmaster's gardener for a time, visiting him there one day in the 1980's I think, I happened to see a very wide cylinder mower parked up. I'd run Reliant three wheeled vehicles after passing my bike test and was amazed to see the very same engine, gearbox and radiator sitting there inside it. Even the oil bath air filter looked the same as the first 600cc Reliant I'd owned, the last one I sold after passing my car test in the late 1980's was the uprated 850cc version.

I do remember jokingly saying to my brother that I'd like to do an engine swap with the mower, as it had obviously done far less miles, he didn't laugh at all, I'm not sure why...!

Clive1962
Offline
Last seen: 9 hours 12 min ago
Joined: 08/01/2020 - 18:45
https://www.facebook.com

https://www.facebook.com/allettmowers/photos/pcb.4912923855415492/491292...

The above link to the current Allett Mowers Facebook page with a couple of photos that they posted up recently showing machine assembly in early Allett days :)

C.

wristpin
wristpin's picture
Offline
Last seen: 5 hours 4 min ago
Joined: 23/05/2012 - 22:09
I remember that when Reg

I remember that when Reg Allett started to market the Reliant engined machine there was a small item about it in the Sunday Times,  and two points from that article have remained remain with me. Firstly that one could conduct a normal conversation while standing beside the running machine, and secondly that Allett offered a same day overhaul service  - presumably using swap units.  No mention of its grass cutting capabilities. 

DJD
Offline
Last seen: 13 hours 3 min ago
Joined: 06/09/2013 - 14:19
Thanks to Clive1962 for that

Thanks to Clive1962 for that link, I enjoyed looking at the videos etc. Never knew it was a Scottish concern.

wristpin
wristpin's picture
Offline
Last seen: 5 hours 4 min ago
Joined: 23/05/2012 - 22:09
Never knew it was a Scottish

Never knew it was a Scottish concern.

It is now as part of Turfmech but Allett started lift in Lincolnshire. I expect that you spotted the rebranded Atcos . When Bosch sold off Atco, Qualcast and Webb etc., the rights to build the Atco cylinder mowers went to Turfmech but not the Atco name that went to GGP to use on Stiga ride-ons etc.

Clive1962
Offline
Last seen: 9 hours 12 min ago
Joined: 08/01/2020 - 18:45
Yes, started out in my home

Yes, started out in my home county :)  Had a spell with Reekie? up in Scotland but now is at Hixon Staffs.

  I didn't get to work on the Reliant engined types but I know a few were about this way.  I am more used to a recent type,  the Buffalo34 firstly with Kubota, and now with Honda.. 

I have had a go with a C34E on a demo and keeping an eye on the Liberty range...as I was quite a supporter of battery mowing of old. Tempted to treat myself to a Liberty...and watching keenly for any developments of the range :)

C.